Connecting The Projector; Connecting A Computer - Sony VPL-SW225 Operating Instructions Manual

B Preparation

Connecting the Projector

Notes
• Make sure all the equipment is powered off when connecting the projector.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; Loose connections may reduce performance of picture signals or
cause a malfunction. When pulling out a cable, be sure to grip it by the plug, not the cable itself.
• For more information, refer also to the instruction manuals of the equipment you are connecting.
• Use a no-resistance audio cable.

Connecting a Computer

Connection with a computer is explained for each input signal.
INPUT A/INPUT B
For connecting a computer with an RGB output terminal.
Computer
Note
It is recommended that you set the resolution of your computer to 1280 × 800 pixels
(VPL-SW235/SW225) or 1024 × 768 pixels (VPL-SX236/SX235/SX226/SX225) for the
external monitor.
INPUT C
For connecting a computer with an HDMI output terminal.
Computer
8
Connecting the Projector
Mini D-sub 15-pin cable (supplied)
RGB output
terminal
Audio output
terminal
Audio cable (Stereo mini plug)
(not supplied)
HDMI cable
(not supplied)
HDMI output
terminal