Windows Nt 4.0 - Oki OKIOFFICE87 Setup Manual

Windows NT 4.0

Note: Administrator's authority is required for installation with
Windows NT 4.0.
1 Make sure that both the printer and the computer are turned OFF.
2 Connect the fax machine and computer with a parallel interface
cable.
3 Turn the fax machine and computer ON and allow Windows to start.
If you see a prompt telling you that a new device has been detected,
press Cancel.
4 Insert the Unimessage Pro XL CD-ROM into your CD-ROM drive.
5 After the setup program has automatically started, click Setup
device driver and Unimessage Pro and follow the on-screen
instructions as appropriate This installs both the printer driver and
the Unimessage Pro software.
Note: If you want to install only the driver, click Setup device driver .
Note: If the setup program does not automatically start or Auto insert
notification is turned off, click Start
D:\SETUP.EXE (where D is the drive letter of your CD-ROM
drive) and click OK .
6 During copying, the Find Fax Port dialog appears and the fax port
is found.
7 When the Modem Installation dialog appears, click OK.
8 When the Install New Modem dialog appears, do the following:
Note: If the Modems Properties dialog appears, click Add and the
Install New Modem dialog pops up.
a Check Don't detect my modem; I will Select it from a list., and
click Next.
b Click Have Disk, and when Install From Disk dialog appears,
type D:\DRIVER\SETUP\DISK1\WINNT40 (where D is the drive
letter of your CD-ROM drive) in Copy manufacturer's files from
and click OK.
c When the Install New Modem screen appears, select the
appropriate device and click Next.
d Check Selected ports, then select the port displayed in Step 6
and click Next.
e Click Finish, and when Modems Properties dialog appears,
click Close.
32 OKIOFFICE 87 Setup Guide
®
Run... Type in