Elements Of The Active Route - Nextar X3-09 Software Manual

To fine-tune 3D visualization on the map, tap the following buttons:
,

4.1.2.3 Elements of the active route

Nextar Navigation System shows the route in the following way:
Symbol Name
Current GPS position
Cursor (selected map
location)
Start point
Via point
Destination (end point)
Route color
Active leg of the route
.
Description
Your current position displayed on the map.
•
In pedestrian mode it is the exact GPS
position.
•
If a vehicle is selected for route calculation,
the arrow is put on the nearest road.
The location selected in the Find menu, or a map
point selected by tapping the map.
The first point of the route.
Normally if GPS position is available, it is the start
point of the route. If there is no valid GPS position,
Nextar Navigation System uses the last known
GPS position as the start point.
When you are using a saved route, Nextar
Navigation System asks you if you want to use
your GPS position or the first point in the saved
route as the start point.
You can also modify the start point in the Cursor
menu. If you do so, automatic off-route
recalculation needs to be turned off to keep the
selected point as the start point.
If automatic off-route recalculation is disabled for
any of the above, tapping the
Turn Preview field not only initiates route
recalculation from the current GPS position, but it
will re-enable the automatic off-route recalculation
as well.
A via point is an intermediate destination. You can
place as many via points as you want.
The last point of the route, the final destination.
The route always stands out with its color on the
map, both in daytime and in night color mode. The
active leg of the route is always displayed in a
brighter shade than the inactive (upcoming) legs.
The section of the route on which you are driving.
If you have not added any via points (only a
destination), the entire route is the active leg. If
you have added via points, the active leg is the
46
, ,
icon in the