Table of Contents
Advertisement
Start using Nextar Navigation System
When Nextar Navigation System is started the first time, you need to do the following:
1.
Select the written language of the application interface. Later you can change it in
Settings (page 64).
2.
Select the language and speaker used for voice guidance messages. Later you can
change it in Settings (page 64).
3.
Read and accept the End User Licence Agreement (page 71).
After this, the Navigation menu appears and you can start using Nextar Navigation System.
The application starts in Simple mode. Later you can switch between the two operating
modes in Settings.
The Navigation menu in Simple mode:
The Navigation menu in Advanced mode:
The typical way of using Nextar Navigation System is to select a destination, and start
navigating. You can select your destination in the following ways (not all of them are available
in Simple mode):
•
Use the selected location on the map (the Cursor) (page 23).
•
Enter a full address or a part of an address, for example a street name without a house
number or the names of two intersecting streets (page 24).
•
Enter an address with ZIP code (page 30). This way you do not need to select the
name of the city and the search for street names might be faster as well.
•
Use a coordinate (page 33)
•
Use a saved location:
•
a Favorite (page 31)
•
a POI (page 31)
•
the History of previously set destinations and waypoints (page 33)
2.1 Simple and Advanced modes
The two operating modes of Nextar Navigation System mainly differ in the menu structure and
the number of available features. The controls and screen layouts are the same.
7
Advertisement
Table of Contents
