Radio Settings; Table 8: Radio Settings Commands - D-Link DWL-6600AP Cli Command Reference

D-Link UAP CLI Command Reference
Action
Set DNS name servers to use static IP
addresses (dynamic to manual mode).
Set DNS name servers to use DHCP IP
addressing (manual to dynamic mode).
Set the IPv6 admin mode.
Set the IPv6 autoconfig admin mode.
Set the static IPv6 address.
Set the static IPv6 prefix length.
View the IPv6 autoconfigured global
addresses.
Set the default IPv6 Gateway.

Radio Settings

Table 8 shows the Radio commands. The commands in this table use radio one (
settings for radio two, use
Action
View a description of the radio interfaces.
Turn the radio on/off.
Enable or disable 802.11d regulatory domain
support.
Enable or disable station isolation.
View the current radio mode.
Set the radio mode to IEEE
Set the radio mode to IEEE 802.11a/n.
Set the radio mode to IEEE
Set the radio mode to IEEE
Set the radio mode to 2.4 GHz
Set the radio mode to 5 GHz
View the radio channel.
Set the radio channel to a static channel.
Set the radio channel to "auto"
D-Link
November 7, 2011
Table 7: Ethernet Settings Commands (Cont.)
Command
set host dns-via-dhcp down
set host static-dns-1 ip_address
set host static-dns-2 ip_address
Example:
set host static-dns-1 192.168.23.45
set host dns-via-dhcp up
set management ipv6-status {up | down}
set management ipv6-autoconfig-status {up | down}
set management static-ipv6 ipv6_address
set management static-ipv6-prefix-length 0–128
get management autoconfig-ipv6-global-all
set static-ipv6-route gateway ipv6_address
.
wlan1

Table 8: Radio Settings Commands

Command
get radio all description
set radio wlan0 status {on | off}
set dot11 dot11d {up | down}
set radio wlan0 station-isolation {on | off}
get radio wlan0 mode
802.11a.
set radio wlan0 mode a
set radio wlan0 mode a-n
802.11b/g. set radio wlan0 mode bg
802.11b/g/n
set radio wlan mode bg-n
IEEE 802.11n. set radio wlan0 mode n-only-g
IEEE 802.11n . set radio wlan0 mode n-only-a
get radio wlan0 channel
set radio wlan0 channel-policy static
set radio wlan0 static-channel channel
set radio wlan0 channel-policy best
). To change the wireless
wlan0
Unified Wired and Wireless Access System
Radio Settings
Page 26