Status; Table 6: Status Commands - D-Link DWL-6600AP Cli Command Reference

D-Link UAP CLI Command Reference

Status

Use the commands in this section to view various AP status information.
Note: Make sure you are familiar with the names of the interfaces as described in
Conventions" on page
the command output shows a wired or wireless interface, the Internal network, or to radio "one" or
radio two."
Action
Global command to get all details on the Basic Service Set (BSS).
This is a useful command to use to get a comprehensive picture
of how the AP is currently configured.
Get information about the wired and WLAN interfaces.
Get the MAC address for the wired internal interface.
Get the VLAN ID for the wired interface.
Get the network name (SSID) for the default virtual access point.
Get the current IEEE 802.11 radio mode.
Get the channel the AP is currently using.
Get basic radio settings for the internal interface.
Get client associations.
Get neighboring access points.
Get information about switches that can discover and manage
the AP.
See the administrative status of the Aeroscout feature.
See the administrative status of the Bonjour protocol.
See the configured time zone.
D-Link
November 7, 2011
20. The interface name you reference in a get command determines whether

Table 6: Status Commands

Command
get bss all detail
get interface
get interface wlan0 mac
get management vlan-id
get interface wlan0 ssid
get radio wlan0 mode
get radio wlan0 channel
get radio wlan0 [detail]
get association detail
get detected-ap detail
get managed-ap
get aeroscout admin-mode
get bonjour status
get system time-zone
Unified Wired and Wireless Access System
Status
"Interface Naming
Page 24