Using The Set Command - D-Link DWL-6600AP Cli Command Reference

D-Link UAP CLI Command Reference
The following example uses the
get mac-acl all mac
get mac-acl all
Note: The name wlan0bssvap0 refers to the basic service set (BSS) on the wlan0 interface. For
information on interfaces, see

Using the Set Command

The command enables you to set the property values of existing instances of a class. It has the following
set
syntax:
set unnamed-class [with qualifier-property qualifier-value ... to] property value . . .
The first argument is an unnamed class in the configuration. Following the argument is an optional qualifier
that restricts the set to only some instances. For singleton classes (with only one instance) no qualifier is
needed. A qualifier starts with the keyword
qualifier-value pairs, and ends with the keyword
value of qualifier-property is qualifier-value will be set. The qualifier-value arguments cannot contain spaces.
Therefore, you cannot select instances whose desired qualifier-value has a space in it.
The rest of the command line contains property-value pairs.
set named-class instance | all [with qualifier-property qualifier-value ... to] property value...
The first argument is either a named class in the configuration.
The next argument is either the name of the instance to set, or the keyword
instances should be set. Classes with multiple instances can be set consecutively in the same command line, as
shown in Example 4 below. The qualifier-value arguments cannot contain spaces.
The following examples show
•
set interface wlan0 ssid "Vicky's AP
• set radio all beacon-interval 200
• set tx-queue wlan0 with queue data0 to aifs 3
• set tx-queue wlan0 with queue data0 to aifs 7 cwmin 15 cwmax 1024 burst 0
• set vap vap2 with radio wlan0 to vlan-id 123
Note: For information on interfaces used in this example (such as wlan0 or vap2) see
Naming Conventions" on page
D-Link
November 7, 2011
command on a named class to get all instances:
get
"Interface Naming Conventions" on page
, and has a sequence of one or more qualifier-property
with
. If these are included, then only instances whose present
to
commands.
set
"
20.
Using the Set Command
20.
, which indicates that all
all
"Interface
Unified Wired and Wireless Access System
Page 15