D-Link DWL-6600AP Cli Command Reference page 31

D-Link UAP CLI Command Reference
Action
Configure the SMTP server password up to 64
characters (including special characters).
Configure email-alert mode to enable/disable
email alert service.
Configure the email-alert log severity level, from 0
(emergency) to 7 (debug). The syslog messages
whose severity levels either match or greater than
the configured level are sent in the email message.
If none is set, then periodic emails are not sent.
Configure the email-alert urgent severity level.
Syslog messages whose severity levels either
match or are greater than the configured level are
sent immediately in an email message. If none is
set, then no emails are sent urgently.
Configure the address from which email alerts are
sent. If it is not configured, then email messages
are not sent.
The amount of time in minutes when email alert
service will send the stored syslog log messages
periodically.
Configure the subject line text for email-alerts, up
to 255 alphanumeric characters.
Configure email-alert addresses.
Send test mail to validate the SMTP server
configuration.
Displays summary or detailed information on the
email alert feature.
D-Link
November 7, 2011
Table 13: Rogue APs and Email Alerts
Command
set email-alert server-password password
set email-alert mode {up | down}
set email-alert log-severity {none | 0-7}
set email-alert urgent-severity {none | 0-7}
set email-alert from-addr email-addr
set email-alert log-duration minutes
email-alert subject <string>
set email-alert to-addr-1 email-addr
set email-alert to-addr-2 email-addr
set email-alert to-addr-3 email-addr
set email-alert test-mail enable
get email-alert [detail]
Rogue APs Traps and Email Alerts
Unified Wired and Wireless Access System
Page 31