Radio Settings; Table 8: Radio Settings Commands - D-Link DWL-8600Ap Reference Manual

D-Link Unified Access Point CLI Reference Manual
Action
Set the IPv6 Admin Mode
Set the IPv6 Auto Config Admin Mode
Set the Static IPv6 Address
Set the Static IPv6 Prefix Length
View the IPv6 Autoconfigured Global
Addresses
Set the Default IPv6 Gateway
R S
ADIO ETTINGS
Table 8 shows the Radio commands. The commands in this table use radio one (
for radio two, use .
wlan1
Action
View a description of the radio interfaces
Turn the radio on
Turn the radio off
Enable or Disable 802.11d regulatory domain support set dot11 dot11d up
Enable or Disable Station Isolation
View the current radio mode
Set the radio mode to IEEE
Set the radio mode to IEEE
Set the radio mode to IEEE
Set the radio mode to IEEE
Set the radio mode to 2.4 GHz
Set the radio mode to 5 GHz
View the radio channel.
Set the radio channel to a static channel.
Set the radio channel to "Auto"
Set the channel bandwidth.
Set the primary channel
Set the channel protection
Set the Beacon Interval
Set the DTIM Interval
© 2001- 2009 D-Link Corporation. All Rights Reserved
16
Table 7: Ethernet Setting Commands
Command
set management ipv6-status {up | down}
set management ipv6-autoconfig-status {up | down}
set management static-ipv6 <ipv6_address>
set management static-ipv6-prefix-length <0–128>
get management autoconfig-ipv6-global-all
set static-ipv6-route gateway <ipv6_address>

Table 8: Radio Settings Commands

802.11a
802.11a/n
802.11b/g
802.11b/g/n (wlan1 only)
IEEE 802.11n
IEEE 802.11n
wlan0
Command
get radio all description
set radio wlan0 status on
set radio wlan0 status off
set dot11 dot11d down
set radio wlan0 station-isolation on
set radio wlan0 station-isolation off
get radio wlan0 mode
set radio wlan0 mode a
set radio wlan0 mode a-n
set radio wlan0 mode bg
set radio wlan1 mode bg-n
set radio wlan0 mode n-only-g
set radio wlan0 mode n-only-a
get radio wlan0 channel
set radio wlan0 channel-policy static
set radio wlan0 static-channel <channel>
set radio wlan0 channel-policy best
set radio wlan0 n-bandwidth {20 | 40}
set radio wlan0 n-primary-channel {lower | upper}
set radio wlan0 protection {auto |off}
set radio wlan0 beacon-interval <20-1000>
set radio wlan0 dtim-period <1-255>
). To change the wireless settings