Troubleshooting; No Lights Are Lit On The Access Point - NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual

802.11g wireless access point

Hide thumbs Also See for WG302 - 802.11g ProSafe Wireless Access Point:

Reference manual (128 pages)

Configuration (3 pages)

Installation manual (2 pages)

Table Of Contents

Table of Contents

This chapter provides information about troubleshooting your WG302 802.11g ProSafe Wireless

Access Point. After each problem description, instructions are given to help you diagnose and

solve the problem. For the common problems listed, go to the section indicated.

•

Is the WG302 on?

•

Have I connected the wireless access point correctly?

Go to

"Installing the WG302 802.11g ProSafe Wireless Access Point" on page

•

I cannot remember the wireless access point's configuration password.

Go to

"Changing the Administrator Password" on page

Note: For up-to-date WG302 installation details and troubleshooting guidance visit

www.NETGEAR.com.

If you have trouble setting up your WG302, check the tips below.

No lights are lit on the access point.

It takes a few seconds for the power indicator to light up. Wait a minute and check the

power light status on the access point.

If the access point has no power.

•

Make sure the power cord is connected to the access point.

•

Make sure the power adapter is connected to a functioning power outlet. If it is in a power

strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify that it

is not a switched outlet.

•

Make sure you are using the correct NETGEAR power adapter supplied with your access

point.