Default Factory Settings - NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual
802.11g wireless access point
Hide thumbs
Also See for WG302 - 802.11g ProSafe Wireless Access Point:
- Reference manual (128 pages) ,
- Configuration (3 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
Reference Manual for the WG302 802.11g ProSafe Wireless Access Point
Default Factory Settings
When you first receive your WG302, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
"WG302 Wireless Access Point Rear Panel" on page
FEATURE
User Name (case sensitive)
Password (case sensitive)
Operating Mode
Access Point Name
IP Configuration
(if DHCP server is unavailable)
Network Name (SSID)
Broadcast Network Name (SSID
Radio Frequency Channel
Restricting connectivity based
on MAC Access Control List
Secure Telnet
3-3
FACTORY DEFAULT SETTINGS
admin
password
Access Point
NETGEARxxxxxx where xxxxxx are the last six digits of the
wireless access point's MAC address
DHCP
DHCP client disabled
IP Address: 192.168.0.228
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
NETGEAR
Enabled
802.11g
11
WEP
Disabled
Disabled
SNMP
Enabled but Trap forwarding is disabled
Enabled
December 2003
2-7.
Basic Installation and Configuration
Advertisement
Table of Contents
Need help?
Do you have a question about the WG302 - 802.11g ProSafe Wireless Access Point and is the answer not in the manual?
Questions and answers