NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual page 41

Table 4-1. CLI Commands
Command
get power
get preamble
get rate
get RTSThreshold
get SSID
get SSIDsuppress
get WirelessIsolate
get WirelessMode
get WlanMac
get WlanState
get WlanVersion
get IPAddress
set authentication
set BeaconInterval
set channel
set CountryCode
set DTIM
set encryption
set FragmentationThreshold
set key
set KeyDefault
set power
set preamble
set rate
set RTSThreshold
set SSID
set SSIDsuppress
set WirelessIsolate
set WirelessMode
del key
Management
Reference Manual for the WG302 802.11g ProSafe Wireless Access Point
Function
Display Transmit Power
Display Only effect on 802.11b rates
Display Transmit rate
Display RTS/CTS Threshold
Display Network name, 1
Display Suppress SSID broadcast
Display Isolate communication between wireless clients
Display Wireless Mode
Display Wlan MAC Address
Display WLAN statistic
Display Wireless driver version
Display IP address setting
Set Authentication Type
Set Beacon period in TU(1024 us)
Set Refer to the result of "get channels"
Set Country and Region
Set DTIM Period in Beacon Interval
Set Data Encryption
Set Fragmentation Threshold (even only)
Set Key table maintenance
Set Default WEP Key ID
Set Transmit Power
Set Only effect on 802.11b rates
Set Transmit rate
Set RTS/CTS Threshold
Set Network name, 1
Set Suppress SSID broadcast
Set Isolate communication between wireless clients
Set Wireless Mode
Delete Key table maintenance
December 2003
4-3