How To Log In To The Wg302 Using Its Default Ip Address - NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual
802.11g wireless access point
Hide thumbs
Also See for WG302 - 802.11g ProSafe Wireless Access Point:
- Reference manual (128 pages) ,
- Configuration (3 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
How to Log In to the WG302 Using Its Default IP Address
192.168.0.228 is the default IP address of your access point. However, the WG302 is also set,
1.
by default, to be a DHCP client. So, if the WG302 has not yet been installed, and there is no
DHCP server on the network, you can log in to the WG302 using its default IP address. You
should use either the NetBIOS name printed on the bottom label to log in.
Note: The computer you are using to connect to the WG302 should be configured with an IP
address that starts with 192.168.0.x and a Subnet Mask of 255.255.255.0.
Open a Web browser such as Internet Explorer or Netscape Navigator.
2.
Connect to the WG302 by entering its default address of
3.
browser.
A login window like the one shown below opens:
4.
Figure 3-3: Login window
Log in use the default user name of admin and default password of password.
Once you have entered your access point name, your Web browser should automatically find
the WG302 Access Point and display the home page, as shown in
page" on page
3-6.
Basic Installation and Configuration
Reference Manual for the WG302 802.11g ProSafe Wireless Access Point
December 2003
http://192.168.0.228
into your
"Login result: WG302 home
3-8
Advertisement
Table of Contents
Need help?
Do you have a question about the WG302 - 802.11g ProSafe Wireless Access Point and is the answer not in the manual?
Questions and answers