How To Restrict Wireless Access By Mac Address - NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual

Reference Manual for the WG302 802.11g ProSafe Wireless Access Point

How to Restrict Wireless Access by MAC Address

To restrict access based on MAC addresses, follow these steps:
Log in to the WG302 using the NetBIOS name printed on the bottom of the unit or at its
1.
default address of
configured. Use the default user name of admin and default password of password, or
whatever LAN address and password you have set up.
Note: When configuring the WG302 from a wireless PC whose MAC address is not in
the access control list, if you select Turn Access Control On, you will lose your wireless
connection when you click Apply. You must then access the wireless access point from a
wired PC or from a wireless PC which is on the access control list to make any further
changes.
From the Wireless Settings menu, click the Wireless Station List button to display the Wireless
2.
Access menu shown below.
Figure 3-6: Access Control List menu
3-15
http://192.168.0.228 or at whatever IP address the unit is currently
December 2003
Basic Installation and Configuration