Yamaha 02R Version 2 Manual page 217

Program 16 — FLANGE–>REVERB1
Flange effect followed by reverb. This effect is more appropriate to emphasize modulation effects than the
CHORUS–>REVERB program. Use the reverb Depth parameter to adjust the amount of reverberation.
Parameter Setting
Freq. 2.4Hz
Depth 68%
FB.Gain +37%
Mod.Dly 254.4ms
Rev.Time 2.6s
Diff. 8
Ini.Dly 10.0ms
LPF 9.0KHz
HPF 45Hz
Depth 61%
Program 17 — FLANGE–>REVERB2
This is a variation of program 16.
Parameter Setting
Freq. 3.3Hz
Depth 9%
FB.Gain –63%
Mod.Dly 0.4ms
Rev.Time 1.4s
Diff. 8
Ini.Dly 9.1ms
LPF 9.0KHz
HPF 45Hz
Depth 56%
Program 18 — EARLY REF.1
Simulates early reflections only. It can create a wide range of effects , from gate-reverb to ambience effects.
Parameter Setting
Type L-Hall
RoomSize 2.5
Liveness 2
Diff. 8
Ini.Dly 23.7ms
ER Num. 15
Hi.Ratio 0.8
FB.Gain 0%
LPF 10.0kHz
HPF THRU
Range
0.1–40.0Hz Flange modulation frequency.
0–100% Flange depth. The amount of modulation.
–99 to +99% Feedback gain. The amount of signal returned to the flanger.
0.0–255.0ms Flange delay. The delay time before modulation begins.
0.3–30.0s Reverb time.
0–10 Reverb diffusion.
0.1–200.0ms Initial delay between the direct sound and early reflections.
1.0kHz–THRU Low pass filter cutoff frequency.
THRU–8.0kHz High pass filter cutoff frequency.
0–100% Reverb depth. The amount of reverb.
Range
Same as program 16 Same as program 16
Range
ER type Choose S-Hall, L-Hall, Random, Reverse, Plate, or Spring.
0.1–20.0 Time interval between the early reflections.
0–10 Rate at which reflected sounds fade or decay.
0–10 Reverb diffusion.
0.1–200.0ms Initial delay between the direct sound and early reflections.
1–15 Number of early reflections.
0.1–1.0 High frequency decay ratio.
–99 to +99% Feedback gain. The amount of signal returned to the effect.
1.0kHz–THRU Low pass filter cutoff frequency.
THRU–8.0kHz High pass filter cutoff frequency.
Internal Effects
Description
Description
Description
02R User's Guide
117