Yamaha 02R Version 2 Manual page 333

Wordclock Selection
1. Power on your DA-88 modular digital multitrack recorder and
then the 02R.
It is always important to observe the correct order for powering up
equipment in a studio. Start with the DA-88 and mastering recorders
and the signal processors, then the 02R, and finally the monitoring
amplifiers and other downstream gear.
2. Use the [DIGITAL I/O] button to locate the DIGITAL I/O 1/5 page.
If the card was installed properly, the 02R should will identify it in the
appropriate slot. The TDIF-1 digital I/O card (CD8-TDII) can be
installed in any slot. You should install the first two cards in SLOT1
and SLOT2 in order to access the direct out lines.
Note: If the W.CLK IN box is not showing a proper wordclock input (no
discrepancy between the input and selected wordclock frequencies), check
the BNC cable between the WORD SYNC OUT connector on the DA-88
and the WORD CLOCK IN connector on the 02R.Check that the DA-88 is
powered on.
3. Use the CURSOR buttons to select the wordclock source.
Use the CURSOR buttons to select the W.CLK IN box and press the
[ENTER] button.
The current wordclock source is indicated by a highlighted icon. See
"Word Clock Select" on page 188 of the User's Guide for further details.
Installing Options
02R User's Guide
235