Yamaha 02R Version 2 Manual page 83

78 Mixing and Automix
AUTOMIX
02R Getting Started Guide
5. Monitor the recording. At the punch-in location, press the [SEL]
buttons for the tape return channels you want to fix.
Recording will begin from the location where you pressed the [SEL] button.
Note: From this point, new events will be recorded and previously existing
events will be deleted.
6. While monitoring the recording, adjust the parameters you want
to fix.
7. When you have finished adjusting the parameters, press the [SEL]
buttons again.
The 02R will return to AUTOMIX RECORD READY status.
Note: If you do not adjust any parameters between the punch-in and punch-out
points, any events of the selected type that were previously recorded there will have
been deleted.
8. Use the CURSOR buttons to select the "STOP" icon and press the
[ENTER] button.
You may find it faster and more convenient to stop the automix recording
session by stopping the device that is providing the timecode. The effect is
the same as if you selected the STOP function on the 02R.
The "REC" icon will change to normal and the "STOP" icon is highlighted.
9. Stop the device that is providing the timecode.
Editing Fader/Encoder Movements
If you are replacing erroneous fader/encoder data using a punch-in, the
02R allows you to monitor the differences on the Fader Edit page.
1. Use the [AUTOMIX] button to locate the AUTOMIX 1/7 page.
2. Use the CURSOR buttons to select the "FADER—Overwrite" item
and press the [ENTER] button.