Download  Print this page

Selecting An Voices (xg Plug-in System); Enabling And Selecting An Voices - Yamaha PLG150-AN Owner's Manual

Analog physical modeling plug-in board modular synthesis plug-in system.
Hide thumbs


Selecting AN Voices (XG Plug-in System)

The PLG150-AN voices can be selected just like the voices of the XG tone generator. Keep in mind,
though, that they can only be selected when the Sound Module Mode is set to XG or Performance.
Also, the Part Assign parameter in the Utility mode (see below) must be set to the desired Part.
The example displays used in the following explanations are all taken from the MU128.

Enabling and Selecting AN Voices

Set the Sound Module Mode to "XG" or "PFM" (Performance).
Press the MODE button and use the SELECT </> buttons.
Set the Part Assign parameter to the desired Part number.
To do this:
1) Press the UTIL button.
2) Select the "PLUGIN" menu (with the SELECT
3) Select the "PLG150-AN" menu if necessary (with the SELECT
4) Select the Part Assign parameter (with the SELECT
tons or dial to change the Part number.
Press the EXIT button to return to the Play mode.
This operation can also be quickly and conveniently done from the AN Easy Editor or AN Expert
Editor (in XGworks).
Enable the PLG150-AN board for the desired Part.
First, make sure that the appropriate Part is selected (using the PART -/+ buttons), then press the
SELECT button. The icon of the selected board appears in the display and the corresponding
LED at the bottom of the panel (PLG-1, -2, or -3) flashes briefly.
The Performance mode is not available on the SW1000XG.
The Part Assign range for the XG mode is 1 - 16 and "off"; for the Performance mode, it is 1 - 4 and
button) and press ENTER.
button), and use the VALUE -/+ but-
buttons), and press


Table of Contents

   Also See for Yamaha PLG150-AN

   Related Manuals for Yamaha PLG150-AN

Comments to this Manuals

Symbols: 0
Latest comments: