Dell PowerEdge M420 Owner's Manual page 78

Error Code Message Information
HWC1009
Message
LCD Message The backplane is absent. Check hardware.
Details
Action
HWC1010
Message
Action
HWC1015
Message The mezzanine card <
Details The mezzanine card may be necessary for proper operation. System functionality may be
degraded.
Action If removal was unintended, check presence, then reinstall or reconnect.
HWC2006
Message
LCD Message The <
Details
Action
HWC2008
Message A fabric mismatch detected between IOM and mezzanine card <
Details The fabric type for the IOM and mezzanine cards must match.
Action Check chassis fabric type in CMC GUI and compare to the type of IOM or mezzanine card.
HWC2011
Message
LCD Message Riser board cable or interconnect failure. Check connection.
Details
Action
HWC3000
Message The <
Details The removed device may be necessary for proper operation. System functionality may be
degraded.
Action If removal was unintended, check presence of the removed device, then reinstall or
reconnect
HWC3002
Message
78
The backplane is absent.
The backplane may be necessary for proper operation. System functionality may be
degraded.
If removal was unintended, check presence, then reinstall or reconnect.
The backplane is disabled.
If disabled unexpectedly, re-enable backplane.
number > is absent.
name > is not installed correctly.
The <
name > is not installed correctly. Check connection.
The device may be necessary for proper operation. System functionality may be
degraded.
Check presence, then re-install or reconnect.
The riser board cable or interconnect is not connected, or is improperly connected.
The riser blade cable may be necessary for proper operation. System functionality may
be degraded.
Check the riser board or interconnect presence, then reinstall or reconnect.
name > is removed.
number > is removed.
Server <
number >.