Dell PowerEdge M420 Owner's Manual page 80

Error Code Message Information
Action
HWC5006
Message
Action
HWC5008
Message
Action
HWC5010
Message
Action
HWC5014
Message
Action
HWC5031
Message
Details
Action
HWC5032
Message
Details
Action
HWC5034
Message
Details
Action
HWC5036
Message
Details
Action
HWC6000
Message
Details
Action
HWC6002
Message
Details
80
Update the CMC firmware. If the issue persists, see
A failure is detected on <
If the issue persists, see
Console is not available for the <
If the issue persists, see
< name > cannot detect any hosts.
If the issue persists, see
name > is not functional and is powered off.
<
If the issue persists, see
number > is offline.
IO module <
The CMC has powered off the IOM.
If the issue persists, see
A fabric mismatch detected on IO module <
The fabric type for IOM's on the same chassis fabric must match.
Check chassis fabric type in CMC GUI and compare to the type of both IOM's.
A link tuning failure detected on IO module <
Link tuning table not supported for this IO modular.
Update the CMC firmware. If the issue persists, see
A failure is detected on IO module <
The IOM module performance may be impacted.
If the issue persists, see
name > controller is offline.
The <
Information and status from the controller is unavailable.
Remove and reapply input power. If the issue persists, see
name > controller is stuck in boot mode.
The <
Information and status from the controller is unavailable.
Getting
name >.
Getting Help.
name >.
Getting Help.
Getting Help.
Getting Help.
Getting Help.
number >.
number >.
Getting
number >.
Getting Help.
Help.
Help.
Getting Help.