Version; Updating Flash Using Afu Command Line - Adaptec SCSI 58300 Installation And User Manual

Example
The following example shows a typical system response after a
performed:
A:\> AFU VERIFY /C 0
Adaptec Flash Utility V1.0-0 B1406
(c)Adaptec Inc. 1999–2005. All Rights Reserved.
Reading flash image file (Build 1406)
Controller #0: Adaptec ASC-48300
File: Checksum: 642C [VALID] (Build 1406)
File: Checksum: 642C [VALID] (Build 1406)
Verified Successfully

VERSION

The command displays version information about the flash components on a
VERSION
HostRAID controller.
Command Syntax
The command syntax for the
AFU VERSION [/C<
Command Switches
For details on the /C switch, see
Example
The following example displays version information about all supported HostRAID
controllers:
A:\> AFU VERSION /C 0
Adaptec Flash Utility V1.0-0 B1406
(c)Adaptec Inc. 1999–2005. All Rights Reserved.
Version Information for Controller #0 (Adaptec ASC-48300)
ROM: Build 1406 [VALID]

Updating Flash Using AFU Command Line

This section provides step-by step instructions for updating the flash.
1
Create the firmware kit on floppy disks (see
2
Power off your computer, insert the first AFU floppy disk, then power on your computer.
If your computer isn't set up to boot from the bootable floppy disk, enter the system setup
utility to change the setting.
3
At the DOS command, if you have multiple controllers and you don't know the number of
the controller you want to update, type
next step.
4
At the DOS command, type AFU followed by a command (see
you want.
Appendix D: Using the Adaptec Flash Utility for DOS
command is as follows:
VERSION
Controller ID
>]
SAVE on page 82.
page
AFU LIST
command has been
VERIFY
80).
, then press Enter. Otherwise, skip to the
page 81) and any switches
84
●