Update; Verify - Adaptec SCSI 58300 Installation And User Manual

A:\> AFU SAVE /C 0
In the following example, the AFU saves flash contents from Controller 1 to a UFI file in
C:\UFI_FILES.
A:\> AFU SAVE /C 1 /D C:\UFI_FILES

UPDATE

The command updates a HostRAID controller's flash components from the flash image
UPDATE
data in a UFI file. You can use the
flash components or to update multiple HostRAID controllers on your computer.
You must restart the computer following an
Command Syntax
The command syntax for the
Controller ID
AFU UPDATE [/C<
Command Switches
For details on the /C and /D switches, see
Examples
The following example shows a typical system response after an update has been performed:
A:\> AFU UPDATE /C 0
Adaptec Flash Utility V1.0-0 B1406
(c)Adaptec Inc. 1999–2005. All Rights Reserved.
Updating Controller 0 (Adaptec ASC-48300)
Reading flash image file (Build 1406)
AFU is about to update firmware on controller(s) Adaptec ASC-48300
***PLEASE DO NOT REBOOT THE SYSTEM DURING THE UPDATE***
This might take a few minutes.
Writing Adaptec ASC-48300 (4MB) Flash Image to controller 0...OK.
Verifying...OK
Please restart the computer to allow firmware changes to take effect.

VERIFY

The command compares the contents of each of the flash components on a HostRAID
VERIFY
controller to the corresponding image in a UFI file and indicates whether they match. Use this
command to determine whether a HostRAID controller's flash components are up-to-date
when compared to a specific UFI file.
Command Syntax
The command syntax for the
Controller ID
AFU VERIFY [/C<
Command Switches
For details on the /C and /D switches, see
Appendix D: Using the Adaptec Flash Utility for DOS
command to update a single HostRAID controller's
UPDATE
command.
UPDATE
command is as follows:
UPDATE
UFI File Path
>] [/D <
SAVE on page
command is as follows:
VERIFY
UFI File Path
>] [/D <
SAVE on page
>]
82.
>]
82.
83
●