Using Sataselect - Adaptec SCSI 58300 Installation And User Manual

SerialSelect Options
SAS Address
Controller Properties
PCI Slot: Bus:
Device:Function
Interrupt (IRQ) Channel
I/O Port Address
Device ID
Controller Serial
Number
Controller WWN

Using SATASelect

The SATASelect utility allows you to change the BIOS and SATA HostRAID controller and
device settings without opening the computer cabinet.
To access SATASelect:
1
Restart the computer, then press Ctrl+A when prompted to access the ARC utility.
2
If multiple HostRAID controllers are installed, select the HostRAID controller you want to
configure, then press Enter.
3
From the ARC menu, select SATASelect Utility.
4
To select a menu option, browse with the arrow keys to the option, then press Enter. In
some cases, selecting an option displays another menu. You can return to the previous
menu at any time by pressing Esc.
5
To restore the default SATASelect values, press F6 from within the SATA Driver and
Controller Configuration screen.
6
To exit SATASelect, press Esc until a message prompts you to exit (if you changed any
settings, you are prompted to save the changes before you exit).
7
At the prompt, select Yes to exit, then press any key to restart the computer. Any changes
you made in SATASelect take effect after the computer restarts.
Available Settings Description
0-F Specifies the last digit of a 64-bit SAS address of
HostRAID
the
using a globally unique worldwide name (WWN)
identifier.
None Displays the path of the storage devices in a Host
RAID controller.
None Displays interrupt
None Displays I/O port address
None Displays device ID
None Displays controller serial number
None Displays the controller WWN
Appendix C: Using the ARC Utility
controller, device, and each port
74
●