Adaptec SCSI 58300 Installation And User Manual page 55

5
Power off your computer, disconnect the power cord, then open the cabinet following the
manufacturer's instructions.
6
Disconnect all cables from the controller, then attach a shorting jumper to the Mode 0
flash connector.
7
Reconnect the power cord, power on your computer, then boot to the floppy disk
containing the AFU.exe file (see
8
At the prompt, type
a:\afu update /c x,
9
Insert the other floppy disks when prompted.
10
When the flash is complete, power off your computer, disconnect the power cord, then
remove the jumper.
11
Close the computer cabinet, reconnect the power cord, then power on your computer.
The controller should boot correctly.
Chapter 10: Solving Problems
Step 3).
where is the controller number.
x
l 55