Select Another Server-Adapter Pair - HP P3410A - NetRAID 1M RAID Controller User Manual

Chapter 2
password. Full Access mode activates features that let you change the
HP NetRAID configuration and the states of physical and logical drives.
For example, in Full Access mode, you can initiate recovery from a disk
failure, or make a new hot spare.
View Only mode does not require a password, and does not permit users to
change the configuration. All menu selections that would change the
configuration are inactive. Examples of operations that you can perform in
View Only mode are displaying the properties of physical and logical
drives and viewing the configuration.
NOTE You cannot enter Full Access mode on a server if it is already
being managed by HP NetRAID Assistant in Full Access
mode, or by another HP NetRAID utility. However, View Only
mode can always be entered.
The only distinction the Main Screen shows between the Full Access and View
Only modes is that in View Only mode various actions are inoperative and the
related menu options are grayed out.
To change to another adapter within the server, use the Adapter pull-down list.

Select Another Server-Adapter Pair

Use these pull-down lists on the HP NetRAID Assistant Main Screen to select the
next server-adapter pair to be viewed or modified.
NOTE
You cannot leave the current server-adapter pair if any
operations--such as Performance Monitor or the rebuilding or
reconstruction of a drive--are running in Full Access mode.
You cannot change from View Only mode to Full Access
mode. Instead, exit HP NetRAID Assistant and restart. Choose
the server and Full Access mode. Then enter the password.
When selecting a new server in Full Access mode, a dialog box appears. Enter the
new server's password, which is case-sensitive. The new server cannot be
accessed if it is already being managed by a system in Full Access mode, or if
either of the following utilities is running on the new server:
HP NetRAID Assistant
HP NetRAID Config
46
HP NetRAID Assistant