HP AH226A - Smart Array E500/256MB Controller RAID Support Manual page 55

The following qualifier must be specified with the bdr command:
bdr
•
When the clear_stat command is run without qualifiers, it clears statistics
clear_stat
of the controller represented by device_file. The following qualifiers may
be specified with the clear_stat command:
•
•
•
•
One of the following sets of qualifiers must be specified with the delete
delete
command:
•
•
Use this set of qualifiers to delete the RAID volume given by the volume ID.
(Use the get_info command with the raid qualifier to obtain the volume
ID.) If a volume ID of all is specified, then all RAID volumes will be deleted.
If the -f option is not specified, sasmgr displays a warning message before
continuing the command. Otherwise, it suppresses the warning message and
continues executing the command. This command requires superuser
privileges. See
•
•
Use this set of qualifiers to delete the controller spare disk. If the -f option is
not specified, sasmgr displays a warning message before continuing the
command. Otherwise, it suppresses the warning message and continues
executing the command. This command requires superuser privileges. See
"Security Restrictions" (page
Disables the controller. This is a destructive operation. The controller will go
disable
offline, all current I/Os will be aborted, and new I/Os will fail. An enable
operation must be performed in order to bring the controller back online. If
the -f option is not specified, sasmgr displays a warning message before
continuing the command. Otherwise, it suppresses the warning message and
executes the command.
Updates the firmware on a SAS controller, enclosure, or SAS disk. You can
download
specify the following qualifiers:
•
•
lun - Resets the specified target device. This is a destructive operation.
If the -f option is not specified with this command, sasmgr displays a
warning message before continuing. Otherwise, it suppresses the warning
message and executes the command.
all - Clears all statistics for the controller, all PHYs, all ports, and all
targets.
phy - Clears statistics for all PHYs or a specific PHY.
phy_in_port - Clears statistics for a port to which the specified PHY
belongs to or clears statistics for all ports.
target - Clears statistics for a specific target or all targets.
raid
raid_vol
"Security Restrictions" (page
raid
spare
downloadfile – The name of the file containing the new firmware.
enc_bay – The enclosure and bay of the disk to update the firmware on.
OR
ctrl – The ID of the external enclosure to update the firmware on.
OR
device_file – The device file of the SAS controller to update. This
qualifier also requires the use of the hba qualifier. For more information
on the use of this command, see
Online" (page 64).
68).
68).
"Updating SAS Controller Firmware
The sasmgr Command Set 55