HP AH226A - Smart Array E500/256MB Controller RAID Support Manual page 30

Discovery Status
Device Identifier
Scan Order
Device Information
SAS Address
Link Error Settings
Link Error Count
Threshold Count
Threshold Time
30 Configuring the Controller Offline
A 32 bit hexadecimal that indicates the discovery status for the
PHY or expander. Possible values:
• Discovery completed successfully - 0x00000000
• Loop Detected - 0x00000001
• Unaddressable device exists- 0x00000002
• Multiple Ports - 0x00000004
• Expander Error - 0x00000008
• SMP Timeout - 0x00000010
• Out of route entries - 0x00000020
• SMP Response Index Does Not Exist - 0x00000040
• SMP Response Function Failed - 0x00000080
• SMP CRC error - 0x00000100
Indicates the ASCII device identifier string extracted from the
device's inquiry data.
Indicates the scan order for this device. This is equivalent to the
SCSI ID value in parallel SCSI configurations.
Indicates whether a device is SAS.
Indicates the SAS address of the device.
Invalid DWORDs
Loss of DWORD Sync
Running Disparity Errors
PHY Reset Errors
Error counts stop when they reach the maximum value.
Actual link error count values since the last PHY Link Error Reset.
a
Link error count threshold values. When a link error count exceeds
the threshold count within the threshold time, the MPT firmware
may reduce the link rate. You can modify the threshold values on
the Advanced Adapter Properties screen.
Time, in seconds, over which to apply Threshold Count. When a
link error count exceeds the threshold count within the threshold
time, the MPT firmware may reduce the link rate. You can modify
the threshold values on the Advanced Adapter Properties screen.
Number of invalid
DWORDs received outside
of PHY reset sequences
since the last PHY link error
reset.
Number of times that
DWORD synchronization
was lost and the link reset
sequence occurred since the
last PHY link error reset.
Number of dwords with
running disparity errors
that have been received
outside PHY reset
sequences since the last
PHY link error reset.
Number of times the PHY
reset sequence has failed
since the last PHY link error
reset.