Parameters; Operation; Display; Syntax - HP AH226A - Smart Array E500/256MB Controller RAID Support Manual

Parameters

<controller #>
[noprompt]

Operation

After entering the DELETE command you will be prompted to be sure if you want to proceed
with the command. Answer "yes" if you want to proceed.

DISPLAY

This DISPLAY command displays information about controller configurations: controller type,
firmware version, BIOS version, volume information, and physical drive information.

Syntax

cfggen <controller #> display [filename]
Parameters
<controller #>
[filename]

Sample Output

Read configuration has been initiated for controller 0
------------------------------------------------------------------------
Controller information
------------------------------------------------------------------------
Controller type
EFI BSD version
Firmware version
Channel description
Initiator ID
Maximum physical devices
Concurrent commands supported
------------------------------------------------------------------------
IR Volume information
------------------------------------------------------------------------
IR volume 1
Volume ID
Status of volume
RAID level
Size (in MB)
Physical hard disks (Target ID)
------------------------------------------------------------------------
Physical device information
------------------------------------------------------------------------
Initiator at ID #63
Target on ID #1
Device is a Hard disk
Enclosure #
Slot #
Target ID
State
Size (in MB)/(in sectors)
Manufacturer
Model Number
Firmware Revision
Serial No
Drive Type
Target on ID #4
Device is a Hard disk
44 Configuring the Controller Offline
A SAS controller number between 0 and 255.
Eliminates warnings and prompts.
A SAS controller number between 0 and 255.
Valid filename to store output of command to a file.
: SAS1068
: 2.00.09.00
: 1.10.01.00
: 1 Serial Attached SCSI
: 63
: 62
: 511
: 2
: Okay (OKY)
: 1
: 34304
: 9 1
: 1
: 8
: 1
: Online (ONL)
: 34732/71132960
: HP
: DG036A8B53
: HPD6
: 3LC04757000085425VFK
: SAS