Table of Contents
Advertisement
To return to the Advanced Adapter Properties screen, press Esc.
To display the next PHY, press N.
To display the previous PHY, press P.
Resetting the Error Counts
To reset the link error counts for this PHY or all PHYs, highlight the Reset Link Error Counts
field and press Enter. The following prompt appears:
Are you sure you want to reset Phy error counts?
Reset error counts for this Phy only
Reset error counts for all Phys
Cancel
To perform the reset, highlight an option and press Enter.
Exiting drvcfg
Because some changes only take effect when you exit drvcfg, follow these steps to exit the
utility:
1.
From Adapter Properties press Esc to return to the Adapter List.
2.
From the Adapter List, press Esc to exit the utility.
The exit screen shows some options that are grey, indicating they are not available. Only available
options are selectable. Your exit choices are as follows:
•
Cancel Exit
•
Save changes and reboot
•
Discard changes and reboot
•
Exit the Configuration Utility and Reboot
The drvcfg Utility
31
Advertisement
Table of Contents
Need help?
Do you have a question about the AH226A - Smart Array E500/256MB Controller RAID and is the answer not in the manual?
Questions and answers