Table of Contents
Advertisement
Faulty controller or peripheral hardware (such as cables, disk drives, etc.) will not cause this
utility to hang. It will exit with the appropriate return value. If an operation fails, clear the fault
condition by whatever means necessary and retry the operation.
DISABLEIR
The DISABLEIR command turns off IR functionality on a SAS controller, by setting the
MPI_IOUNITPAGE1_DISABLE_IR bit in the IO Unit 1 MPT Configuration Page.
Syntax
cfggen <controller #> disableir
Parameters
This command does not require <controller #>.
Sample Output
Vendor
Device
Index
ID
-----
------
0
1000h
0054h
LOCATE
The LOCATE command turns locate LED's on and off.
Syntax
cfggen <controller #> locate
Parameters
<controller #>
Updating SAS Controller Firmware Offline
Follow the procedures in this section to update the SAS controller firmware offline. For
information on recommended firmware versions, see the SAS Host Bus Adapters Support Matrix
at:
http://docs.hp.com/en/netcom.html
There are two methods to update the SAS controller firmware offline, depending on the HP-UX
and SerialSCSI-00 versions installed on the server:
•
In some SerialSCSI-00 bundle versions, the sasd driver updates the adapter firmware when
the system boots.
•
In later SerialSCSI-00 versions, the firmware is not updated by the driver. Use the sasflash
EFI utility to update adapter firmware offline.
Table 3-2
lists the method you must use to update the adapter firmware for each supported
HP-UX and SerialSCSI-00 bundle version.
Table 3-2 Adapter Firmware Update Methods
HP-UX Version
HP-UX 11i v3
HP-UX 11i v2
48
Configuring the Controller Offline
ID
Bus Device
------
---------
14h 08h LSI 1068 SAS Host Adapter
A SAS controller number between 0 and 255.
SerialSCSI-00 Version
B.11.31.0803 or later
B.11.31.0712 or earlier
B.11.23.0803 or later
B.11.23.0712 or earlier
Adapter Firmware Update Method
sasflash.efi
sasd driver
sasflash.efi
sasd driver
Advertisement
Table of Contents
