Presser Foot Installation Position; Changing The Intermittent Stroke - Brother BAS-342G Instruction Manual

Direct drive, programmable electronic pattern sewer

Hide thumbs Also See for BAS-342G:

Table of Contents

11. STANDARD ADJUSTMENTS

11-12. Presser foot installation position

The intermittent stroke can be adjusted to within 2 − 10 mm by adjusting the position of the stepping clamp connecting rod

and changing the installation position of stepping clamp link A.

1. Remove the face plate.

2. Remove the two screws (1) and the two shoulder screws (2), and then remove stepping clamp link A (3).

3. Change the installation position for stepping clamp link A (3) to either A, B or C above.

If the position of the stepping clamp connecting rod is adjusted as described in the following at any one of the installation

positions, the adjustment range for the intermittent stroke will as given in the following table. (Refer to the next page.)

Installation position

5031Q

2 − 4.5mm

4.5 − 10mm

0 mm (Presser foot does not move up and down)

BAS-342G

Install the presser foot (1) with the screw (2) so that the

distance from the bottom of the presser foot to the top of the

needle plate is 22 mm when the sewing machine is stopped

and the presser foot (1) is raised.

Intermittent stroke range

4049M

5012Q

Table of Contents

Show Quick Links

Table of Contents