Adjusting The Thread Wiper; Intermittent Presser Foot Installation Position (-484 Sf Specifications Only) - Brother BAS-326H-484 Instruction Manual

7. STANDARD ADJUSTMENTS

7-13. Adjusting the thread wiper

4702M
4703M
1. Close the air cock (1).
2. Loosen the two screws (4) and shift the entire solenoid setting plate (5) up or down to adjust so that the thread wiper (3) is
15 mm in front of the needle center when the thread wiper cylinder (2) is pushed up to its full stroke.
3. Loosen the screw (6) and adjust the position of the thread wiper (3) so that the distance from the thread wiper to the tip of
the needle is approximately 2 mm and the tip of the thread wiper (3) is approximately 3 mm from the center of the needle
when the thread wiper (3) passes below the needle during operation.
NOTE: Check that the thread wiper (3) does not touch the finger guard.
4. Open the air cock (1).
7-14. Intermittent presser foot installation position
(-484 SF specifications only)
44
Open
Close
Install the intermittent presser foot (1) with the screw (2)
so that the distance from the bottom of the intermittent
presser foot to the top of the needle plate is 19.5 mm
when the sewing machine is stopped and the
intermittent presser foot (1) is raised.
4706M
BAS-326H-484, BAS-326H-484 SF
Approx. 3mm
4704M
Approx. 2mm
4705M