Installing The Tower Front Panel And Control Panel Assembly; Removing The Rack Control Panel Assembly - Dell PowerEdge 2800 Conversion Manualline

Y1001bk0.book Page 28 Thursday, July 8, 2004 4:32 PM
Figure 1-17. Removing the Rack Control Panel Assembly
Using a T-10 Torx driver, remove the 22 screws that secure the rack front panel to the drive
tray. See Figure 1-17

Installing the Tower Front Panel and Control Panel Assembly

Install the tower front panel. See Figure 1-17.
Orient the system as shown in Figure 1-17.
a
Using a T-10 Torx driver, install the 22 screws (that came in your kit) that secure the
b
tower front panel to the drive tray.
NOTE:
rack systems. Only the carrier is different. When converting your rack system to a tower system, you must
remove the LCD board and the I/O board from the control panel assembly that you removed in step 2 of
"Removing the Control Panel Assembly and Rack Front Panel."
28
Tower-to-Rack and Rack-to-Tower Conversion Guide
control panel
cable clamp
The control panel assembly's LCD board and the I/O board are the same for both the tower and
control panel
assembly
screws (2)
T-10 Torx
screws (22)