Removing The Trim Panel - Dell PowerEdge 2800 Conversion Manualline

Y1001bk0.book Page 16 Thursday, July 8, 2004 4:32 PM

Removing the Trim Panel

Remove the trim panel.
Lay the system on its cover as shown in Figure 1-7.
a
Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the three screws from the
b
side of the trim panel. See Figure 1-7.
Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the two screws from the
c
back of the system.
Slide the trim panel backward and then remove the trim panel from the chassis.
d
Figure 1-7. Removing the Trim Panel
Install the six shoulder nuts as shown in Figure 1-8.
NOTE:
the side.
The system is ready to install in the rack.
16
Tower-to-Rack and Rack-to-Tower Conversion Guide
Ensure that the shoulder nuts are tightened so that the shoulder of the nut is tight against
hex-head Phillips
screws (2)
hex-head Phillips
screws (3)