Installing The Metal Feet - Dell PowerEdge 2800 Conversion Manualline

Tower-to-rack and rack-to-tower conversion guide

Hide thumbs Also See for PowerEdge 2800:

Table of Contents

Y1001bk0.book Page 30 Thursday, July 8, 2004 4:32 PM

Insert the two tabs on the metal foot into the slots on the side of the system.

Rotate the metal foot down and over the hole in each corner and secure the foot with a hex-

head Phillips screw that came with the metal foot kit. See Figure 1-18.

Repeat this step for the other three metal feet.

Figure 1-18. Installing the Metal Feet

metal foot tabs

and slots (2)

Orient the system as shown in Figure 1-19.

If applicable, install the optional tower bezel (see Figure 1-19):

To install the bezel hook the left end of the bezel onto the chassis, then fit the free end of the

bezel onto the system. Secure the bezel with the keylock.

Tower-to-Rack and Rack-to-Tower Conversion Guide

metal feet (4)

flat working surface

hex-head Phillips

screws (4)

Table of Contents