Dell 5535 Mono Laser User Manual page 29

The system board has two connections for an optional flash memory or firmware card. Only one of each may be
installed, but the connectors are interchangeable.
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have any other devices attached to the printer, then turn them off as well,
and unplug any cables going into the printer.
Warning—Potential Damage: System board electronic components are easily damaged by static electricity. Touch
something metal on the printer before touching any system board electronic components or connectors.
1
Access the system board.
2
Unpack the card.
Note: Avoid touching any electrical components on the card.
3
Holding the card by its sides, align the plastic pins on the card with the holes on the system board.
1 Plastic pins
2
Metal pins
Additional printer setup
29