Menu item
Print Area
Normal
Whole Page
Download Target
RAM
Flash
Disk
Job Accounting
On
Off
Description
Sets the logical and physical printable area
Notes:
This menu does not appear if Edge to Edge is enabled in the
•
printer Setup menu.
Normal is the factory default setting. When attempting to
•
print data in the non-printable area defined by the Normal
setting, the printer clips the image at the boundary.
The Whole Page setting allows the image to be moved into
•
the non-printable area defined by the Normal setting, but the
printer will clip the image at the Normal setting boundary.
The Whole Page setting only affects pages printed using a
•
PCL 5e interpreter. This setting has no effect on pages printed
using the PCL XL or PostScript interpreter.
Sets the storage location for downloads
Notes:
RAM is the factory default setting.
•
Storing downloads in flash memory or on a printer hard disk
•
places them in permanent storage. Downloads remain in
flash memory or on the printer hard disk even when the
printer is turned off.
Storing downloads in RAM is temporary.
•
This menu appears only if a flash and/or disk option is
•
installed.
Specifies whether the printer stores statistical information about
the most recent print jobs on the hard disk
Notes:
Off is the factory default setting. Off means the printer does
•
not store job statistics.
The statistics include a record of print errors, the print time,
•
the job size in bytes, the requested paper size and type, the
total number of printed pages, and the total number of copies
requested.
Job Accounting is available only when a printer hard disk is
•
installed and working properly. It should not be Read/Write
or Write protected. Job Buffer Size should not be set to 100%.
Changing this setting from the printer control panel and then
•
exiting the menus causes the printer to reset. The menu
selection is updated.
Understanding printer menus
217