Maytag MTW6700TQ - 28" Washer Use And Care Manual page 7

Check withaqualified electrician ifyouare
not sure the washer is properly grounded.
Do not have a fuse ill the neutral or ground circuit.
GROUNDING INSTRUCTIONS
For a grounded, cord-connected washer:
This washer must be grounded. In the event of a malfunction
or breakdown, grounding will reduce the risk of electrical
shock by providing a path of least resistance for electric
current. This washer is equipped with a cord having an
equipment-grounding conductor and a grounding plug. The
plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local
codes and ordinances.
WARNING:
Improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance - if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
For a permanently connected washer:
This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or lead on
the appliance.
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
NOTE: [o avoid floor damage during installation, set the washer onto cardboard before
moving across floor.
IMPORTANT:
• Be sure the foam shipping base has been removed from the bottom of the washer as
directed in the Unpacking Instructions.
• If foam shipping base has not been removed, be sure lid is secured with tape before laying
washer on its back.
• Removing the foam shipping base is necessary for proper operation.
t. Place cardboard supports from shipping carton on floor behind washer for support.
2. Secure the lid with tape.
3. Using 2 or more people, tip the washer onto its back and place on cardboard supports.
4. Remove foam shipping base.
5. Set washer upright.
6. Remove tape from lid. Open lid and remove foam packing ring from washer tub. Keep
foam packing ring in case you need to move the washer in the future.
F_