Serveraid Error Codes - IBM 884155U User Manual

ServeRAID error codes

In the following error codes, x can be any number or letter.
For more information about ServeRAID errors, see the IBM ServeRAID: User's
Reference.
Note: See "System replaceable units" on page 144 to determine which components should be replaced by a field
service technician.
Error code/symptom
1xxx to 7xxx (POST detected an internal error)
2601 to 260B (POST detected an error with the
ServeRAID subsystem)
2610 (POST detected an error with the ServeRAID
controller hardware)
2620 (POST detected that a ServeRAID configuration or
hard disk error occurred)
3E20H (POST detected that the ServeRAID controller is
in the wrong PCI expansion slot)
3E21H (POST detected that the ServeRAID controller did
not find the integrated SCSI controller)
3E2xH (POST detected an error with the integrated SCSI
controller: either the wrong controller was found or some
other SCSI controller error occurred)
8xxx to Bxxx (POST detected an error with the SCSI
interface)
FRU/action
1. Install download jumpers, flash latest level BIOS and
firmware for controller, then remove jumpers.
2. ServeRAID controller.
1. Install download jumpers, flash latest level BIOS and
firmware for controller, then remove jumpers.
2. ServeRAID controller.
1. Install download jumpers, flash latest level BIOS and
firmware for controller, then remove jumpers.
2. ServeRAID controller.
1. Start the IBM ServeRAID Support CD and view the
existing device and configuration information for your
ServeRAID subsystem.
2. Install download jumpers, flash latest level BIOS and
firmware for controller, then remove jumpers.
3. ServeRAID controller.
1. Install the ServeRAID controller in the correct PCI
expansion slot; see the documentation that came with
your server for more information.
2. Install download jumpers, flash latest level BIOS and
firmware for controller, then remove jumpers.
3. ServeRAID controller.
1. Make sure the ServeRAID controller is in the correct
PCI expansion slot; see the documentation that came
with the server for more information.
2. Install download jumpers, flash latest level BIOS and
firmware for controller, then remove jumpers.
3. ServeRAID controller.
1. Install download jumpers, flash latest level BIOS and
firmware for controller, then remove jumpers.
2. ServeRAID controller.
1. Verify that the SCSI cables are correctly connected
and the SCSI termination is set properly for each
installed SCSI device.
2. Install download jumpers, flash latest level BIOS and
firmware for controller, then remove jumpers.
3. ServeRAID controller.
Chapter 6. Symptom-to-FRU index
133