Table of Contents
Advertisement
Installing and Configuring the Windows NT Driver
5.1
New Intel
Adapter Installation
20
®
PRO/Wireless 2011 LAN
To install the Intel
the first time in Windows NT:
Verify there is no existing Intel
LAN Windows NT driver in the system. If there is an
existing driver, remove it and complete the instructions
in this section.
If IRQ or I/O conflicts occur during the installation,
configure the IRQ and I/O addresses for available
values. Refer to the Windows NT Diagnostics Tool to
verify the values. Use the NCPA WLAN Adapter page to
set the Interrupt Number, the I/O Port Address and the
Memory Base Address values.
1. Install the WLAN adapter as described in
Chapter 3.
2. Power up the system.
3. Insert the Intel
driver installation CD.
4. Click Start, select
5. Click on the
tab. Click Add.
6. Click
Have
A window appears prompting for the location of the
driver files.
Wireless LAN Adapter Product Reference Guide
®
PRO/Wireless 2011 LAN driver for
®
®
PRO/Wireless 2011 LAN Windows
Settings
Network
icon and select the
Disk.
PRO/Wireless 2011
and
Control
Panel.
Adapters
Advertisement
Table of Contents
Troubleshooting
