Connecting A J-Ex Series Switch To A Network For Out-Of-Band Management - Dell PowerConnect J-EX8208 Hardware Manual

Dell PowerConnect J-Series J-EX8208 Ethernet Switch Hardware Guide
Related
Documentation

Connecting a J-EX Series Switch to a Network for Out-of-Band Management

140
Connect one end of the phone cable to the modem and the other end to your telephone
7.
network.
Turn on the power to your modem.
8.
Power on the switch.
9.
Connecting a J-EX Series Switch to a Management Console on page 135
Console Port Connector Pinout Information for a J-EX Series Switch on page 43
You can monitor and manage a J-EX Series switch using a dedicated management
channel. J-EX Series switches have a management port with an RJ-45 connector for
out-of-band management. Use the management port to connect the J-EX Series switch
to the management device.
Ensure that you have an Ethernet cable with an RJ-45 connector available. One such
cable is provided with the switch. Figure 71 on page 140 shows the RJ-45 connector of the
Ethernet cable supplied with the switch.
Figure 71: Ethernet Cable Connector
To connect a J-EX Series switch to a network for out-of-band management (see Figure
72 on page 141):
Connect one end of the Ethernet cable to the management port (labeled
1.
the J-EX Series switch.
For the location of the
Module in a J-EX8208 Switch" on page 22.
Connect the other end of the Ethernet cable to the management device.
2.
port, see "Switch Fabric and Routing Engine (SRE)
MGMT
) on
MGMT