Powering On A J-Ex8200 Switch - Dell PowerConnect J-EX8208 Hardware Manual

Related
Documentation

Powering On a J-EX8200 Switch

Figure 65: Connecting the Power Supply Cord to a J-EX8200 Switch
Powering On a J-EX8200 Switch on page 133
AC Power Supply in a J-EX8200 Switch on page 34
AC Power Supply LEDs in a J-EX8200 Switch on page 37
Before you power on the switch, ensure that:
You have installed all required switch components.
You have installed the required number of power supplies to support redundant
operation for the switch configuration (see "Calculating Power Requirements for a
J-EX8208 Switch" on page 79.
You understand how to protect the switch from electrostatic damage. See "Prevention
of Electrostatic Discharge Damage on J-EX Series Switches" on page 236.
Ensure that you have the following parts and tools available to power on the switch:
An electrostatic discharge (ESD) grounding strap.
An external management device such as a PC.
A cable to connect the external management device to the master Switch Fabric and
Routing Engine (SRE) module's console (CON) port or management (MGMT) port in
a J-EX8208 switch.
For connecting a management device to the console port, see "Connecting a J-EX
Series Switch to a Management Console" on page 135. For connecting a management
Chapter 10: Connecting the Switch
133