Removing The Switch; Powering Off A J-Ex8200 Switch - Dell PowerConnect J-EX8208 Hardware Manual

CHAPTER 12

Removing the Switch

Powering Off a J-EX8200 Switch

Powering Off a J-EX8200 Switch on page 151
Removing a J-EX8208 Switch from a Rack or Cabinet on page 152
Removing a J-EX8208 Switch from a Rack or Cabinet Using a Mechanical Lift on page 154
Removing a J-EX8208 Switch from a Rack or Cabinet Without Using a Mechanical
Lift on page 156
Before you power off the switch:
Ensure that you understand how to prevent electrostatic discharge damage. See
"Prevention of Electrostatic Discharge Damage on J-EX Series Switches" on page 236.
Ensure that you do not need to forward traffic through the switch.
Ensure that you have the following parts and tools available to power off the switch:
An electrostatic discharge (ESD) grounding strap
An external management device such as a PC
A cable to connect the external management device to the console port (CON) or
management port (MGMT) on the master Switch Fabric and Routing Engine (SRE)
module in a J-EX8208 switch.
To power off a switch:
Connect a management device to the master SRE module in a J-EX8208 switch. For
1.
connecting a management device to the console (CON) port, see "Connecting a J-EX
Series Switch to a Management Console" on page 135. For connecting a management
device to the management (MGMT) port, see "Connecting a J-EX Series Switch to a
Network for Out-of-Band Management" on page 140.
If the switch has two SRE modules, shut down the backup SRE module first. (If your
2.
switch has only one SRE module, skip to Step 2.) From the external management PC
connected to the master SRE module, issue the
operational mode CLI command.
other-routing-engine
This command shuts down the backup SRE module gracefully. A message displays
on the console confirming that the backup SRE module has halted.
request system halt
151