Dell PowerConnect J-EX8208 Hardware Manual page 174

Dell PowerConnect J-Series J-EX8208 Ethernet Switch Hardware Guide
158
If you installed the switch with square-hole cage nuts, a flat-blade (-) screwdriver to
remove the cage nuts
To remove the switch from the rack (see Figure 79 on page 158):
Use the appropriate Phillips (+) screwdriver to remove the 24 mounting screws—and
1.
washers if you installed the switch with cage nuts—that attach the chassis
front-mounting brackets to the rack or cabinet.
WARNING: To prevent injury, keep your back straight and lift with your
legs, not your back. Do not twist your body as you lift. Balance the load
evenly and be sure that your footing is firm.
With one person on each side and one person in the back, hold onto the bottom of
2.
the chassis and carefully lift it out of the adjustable mounting brackets attached to
the rack. If you have a pallet jack, move the switch onto the pallet jack.
Figure 79: Removing a J-EX8208 Switch Chassis Without Using a
Mechanical Lift
Carefully move the chassis to its new location.
3.
If you installed the switch with cage nuts, remove the cage nuts from the rack.
4.
Use Figure 80 on page 159 or Figure 81 on page 159 to help you with cage-nut removal.