Dell PowerConnect J-EX8208 Hardware Manual page 35

Table 10: LCD Panel Menu Options for the J-EX8200 Switch (continued)
Menu Description
Maintenance The Maintenance menu has the following options:
SYSTEM HALT?—Choose one of the following:
Press
In a redundant configuration, the backup SRE module takes over mastership when the master SRE module
is halted. To completely halt the switch, use the
to halt the backup SRE module before halting the master SRE module. Press
device or power cycle the switch to bring the switch back up.
See "J-EX8208 Switch Configurations" on page 6 for information on configuration types.
Press
SYSTEM REBOOT?—Choose one of the following:
Press
Press
LOAD RESCUE?—Choose one of the following:
Press
rollback.
Press
FACTORY DEFAULT?—Choose one of the following:
Press
restoration. The LCD flashes a success or failure message and returns to the Idle menu.
Press
ENTER EZSETUP?—Choose one of the following:
Press
EZSetup configures DHCP and enables the J-Web user interface on the switch. The LCD flashes a success
or failure message for approximately 10 seconds and returns to the Idle menu.
Press
NOTE: You can use the EZSetup option only if the switch is in the factory default configuration.
EXIT MAINT MENU?—Choose one of the following:
Press
Press
If you do not want users to use Maintenance menu options, disable the entire menu or individual menu options.
For instructions, see the Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS at
http://www.support.dell.com/manuals
Related
Documentation
to halt the master SRE module in a J-EX8208 switch. Press
Enter
to go to the next option in the Maintenance menu.
Menu
to reboot the master SRE module. Press
Enter
Menu to go to the next option in the Maintenance menu.
to roll back the switch to the previous valid configuration. Press
Enter
to go to the next option in the Maintenance menu.
Menu
Enter to restore the switch to the factory default configuration. Press
to go to the next option in the Maintenance menu.
Menu
to launch EZSetup. Press
Enter
to go to the next option in the Maintenance menu.
Menu
to exit the Maintenance menu.
Enter
to return to the SYSTEM HALT option.
Menu
You can view the information about the LCD panel in J-EX8200 switches by executing
the command
show chassis hardware
and description of the LCD panel.
Chassis Status LEDs in a J-EX8200 Switch on page 20
Field-Replaceable Units in a J-EX8208 Switch on page 21
Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 144
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 146
request system halt other-routing-engine
again to confirm the reboot.
Enter
again to confirm the launch.
Enter
.
. It shows the version, part number, serial number,
Chapter 2: Component Descriptions
again to confirm the halt.
Enter
CLI command
on your management
Enter
again to confirm the
Enter
Enter again to confirm the
19