Installing The Interconnect Tray; Removing A Hot-Plug Power Supply - Compaq BL10e - HP ProLiant - 512 MB RAM Setup And Installation Manual

Installing and Cabling the System

Installing the Interconnect Tray

Before installing an interconnect tray into the enclosure, you must first purchase one
as an option. The Integrated Administrator module is included with each interconnect
tray.
NOTE: The installation procedure is the same for any interconnect tray.
To install the interconnect tray:
1. Press the port-colored latch to release one hot-plug power supply (1).
NOTE: Port-color indicates hot-plug components.
2. Open the handle (2).
3. Slide the hot-plug power supply out of the enclosure (3).
Figure 3-1: Removing a hot-plug power supply
4. Repeat steps 1 through 3 to remove the other hot-plug power supply.
3-2 HP ProLiant BL e-Class System Setup and Installation Guide