General Control - Sharp Aquos AN-ACS1U Operation Manual

General control

Volume control
Main unit operation:
Press VOLUME + to increase the volume and VOLUME - for
decreasing.
Remote control operation:
Press VOLUME + to increase the volume and VOLUME - for
decreasing.
Muting
The sound is muted temporarily when pressing MUTE on the
remote control.
Press again to restore the sound.
NOTE
• When you press another button, muting is canceled.
However, it is not canceled if INPUT or MENU is pressed.
• When the unit is tuned off and back on again, muting is canceled.
18
Subwoofer control
The subwoofer level can be adjusted.
Press SUBWOOFER LEVEL.
• The current subwoofer level setting is shown. When you
press the button again while the level is shown (within 3
seconds), you can change the subwoofer level.
To increase the level, press SUBWOOFER LEVEL +.
To decrease the level, press SUBWOOFER LEVEL -.
Shown for about 3 seconds
• If the subwoofer level is too high, resulting in distortion, you
should lower the level.
To change the tonal quality of the sound
You can choose among three sound modes for the tonal
quality.
Press TONE.
• The current sound mode is shown.
When you press the button again while the mode is shown
(within 3 seconds), you can change the sound mode.
• Each push of the button cycles through the following settings.
NORMAL
Shown for about 3 seconds
To dim the display
1
Press MENU.
2
Use c/d to select
"DIM".
3
a
Use to select "ON"
and press ENTER.
• The display will be turned off.
• If DVS or Audistry has been selected, the respective sound
mode icon will be shown also while the display is off.
• If a button is pressed while the display is dimmed, the
current setting will be shown for 3 seconds, and then the
display goes off again.
To cancel the setting
b
Use to select "OFF" and then press ENTER.
HEAVY LIGHT