Sharp Aquos AN-ACS1U Operation Manual page 16

Connections
Connecting a TV (with HDMI connector)
Use both the optical digital cable and HDMI cable for the connection.
To use the AQUOS LINK function (pages 24 - 27), connect the audio signal of the TV to the AUX1 connector. If AUX2 is used,
you must manually select the AUX2 input.
Cables to use
Optical digital cable (supplied)
HDMI cable (supplied)
If the cable is equipped with a protective
cap, remove it before making the
connection.
NOTE
• If only the HDMI cable is used for the
connection, the sound of the TV cannot
be reproduced by the AQUOS AUDIO
system. To reproduce the sound of the
TV with the AQUOS AUDIO system, the
optical digital cable must be connected.
• When connecting an HDMI CEC-enabled
AQUOS TV or similar component, the
AQUOS LINK function can be used.
(Pages 24 - 27)
Connecting a TV (without HDMI connector)
Use the optical digital cable for the connection.
If the TV does not have a digital audio output, use regular audio cable to make an analog connection.
Cables to use
Optical digital cable
(supplied or commercially available)
If the cable is equipped with a protective
cap, remove it before making the
connection.
Audio cable (commercially available)
Left (white)
Right (red)
14
TV
HDMI cable
To HDMI OUTPUT
(TO TV) connector
Rear panel
(amplifier part)
TV
Left (white)
Right (red)
To AUDIO INPUT
connectors
(AUX3 or AUX4)
Rear panel
(amplifier part)
HDMI
To HDMI input connector
Connect both
cables
Insert cable until you hear a click.
To AUDIO output jacks
Audio cable
Make one of these
connections (not both)
AQUOS LINK
To DIGITAL AUDIO
AUDIO
output (optical) connector
DIGITAL
Optical
digital cable
To DIGITAL AUDIO
INPUT (OPTICAL)
connector (AUX1)
To DIGITAL AUDIO
AUDIO
output (optical) connector
DIGITAL
or
AUDIO
L
R
Optical
digital cable
To DIGITAL AUDIO INPUT
(OPTICAL) connector
(AUX1 or AUX2)
Insert cable until you hear a click.