Installing The Unit - Sharp Aquos AN-ACS1U Operation Manual

Installing the unit

Before installation
• Because this unit is extremely heavy, it must always be handled by at least
two persons, to prevent the risk of injury and accidents.
• For safety, protective gloves should be worn when handling the unit.
• For information on supplied parts and accessories, please see page 6.
• Take care not to scratch the fl oor etc. when moving the unit.
• Do not touch the speaker mesh on the front side when moving the unit.
Otherwise the mesh or the speakers may be damaged.
• Never place the unit on an unstable surface or any surface unable to sustain
its weight. Otherwise the unit may fall over or drop, and there is a risk of
damage and injury.
• Before moving the unit, be sure to turn power off and disconnect the power
cord from the AC outlet. Also disconnect all cables from other components.
Double-check this before you begin. Otherwise there is a risk of damage and
injury.
• Do not move the unit with a TV or other component on top. Otherwise such a
component may fall over or drop, and there is a risk of damage and injury.
• The glass parts are made of reinforced glass, but dropping pointed objects
on them or strongly hitting a glass surface may cause it to break. Always take
proper precautions.
Placing the top glass cover and glass shelf on the unit
Caution:
• This procedure should be performed by at least two people.
• The top glass cover and glass shelf are not fastened to the
unit.
• After placing the top glass cover and glass shelf on the
unit, take care to keep the unit level when transporting it.
Otherwise these parts may fall off, and there is a risk of
damage and injury.
Attaching the wall spacers
The wall spacers can be attached to the rear side of the top section of the unit (two locations, right and left).
• The wall spacers serve to ensure proper clearance behind the unit and protect the connection cables from damage.
Caution:
• Do not carry the unit by holding the wall spacers.
• When moving the unit, grasp it at the areas marked by arrows
on the underside of the top board.
• Do not carry the unit by holding the metal frame that supports
the glass shelf.
Position the top glass Position the top glass
cover and glass shelf cover and glass shelf
correctly as shown here. correctly as shown here.
Glass shelf Glass shelf
Wall spacer Wall spacer
(supplied) (supplied)
Insert wall Insert wall
spacer here spacer here
(2 locations) (2 locations)
Speaker mesh sections Speaker mesh sections
Top glass cover Top glass cover
Glass shelf cushion pads Glass shelf cushion pads
(already attached to the unit) (already attached to the unit)
Precaution label Precaution label
Rear view Rear view
Logo sticker Logo sticker
Top glass cover Top glass cover
cushion pads cushion pads
(already attached (already attached
to the unit) to the unit)
Wall spacer Wall spacer
(supplied) (supplied)
11