5. Attach the covers to the projector adapter and the wall adapter
Attach cover (A) (with hook) and cover (B) (with notch) to the upper side of the wall adapter
Slide the two coverstowards the center while pushing them down, as shown in the
illustration. The bottom of each cover will then engage with the screw heads of the wall
adapter. At the same time, the hook of cover (A) will enter the notch of cover (B), thereby
locking the covers.
On the bottom side of the wall adapter, reverse the positions of covers (A) and (B) and attach
them in the same way as described in
Attach the arm cover .
The cover is fixed when the left and right tabs engage with the notches on the projector
Cover (B) should be at left
External dimensions:280 (W) x 883 (D) x 219 (H) mm
•Specifcations and design are subject to change without notice.
Wall mount unit
Up-down angle ±3°, left-right angle ±3° , inclination angle ±10°
Front-rear ±100 mm, left-right ±50 mm, up-down ±50 mm
Approx. 7.5 kg
Cover (A) should be at right